Grafik eye operation manual






















GRAFIK Eye Series. Use with GRAFIK Eye Dimming or Switching Panels; Control up to 32 panels and circuits. Define 4 Scenes and 2, 3, 4, 6, 8, 16 or 24 Zones. GRAFIK Eye is expandable to 16 scenes and 64 zones. Link up to 8 GRAFIK Eye Control Units (8 addresses) for up to 64 zones. GRAFIK Eye ® QS System Installation and Operation Guide 3 Wiring the GRAFIK Eye ® QS System Important Wiring Information • Use properly certified cable for all line voltage/mains cables. • Proper short-circuit and overload protection must be provided at the distribution panel. You can use up to a 20 A maximum circuit breaker/MCB for your. Review LUTRON GRX-TVI Ten Volt GRAFIK EYE Interface Power Supply Box Manual. It is black color. This listing is for a new in box unused LUTRON GRAFIK EYE control interface. I do accept Paypal for this listing. Thanks new condition. I also shipped FedEx. I also do discount shipping on multiple items you buy. It also comes with manual.


GRAFIK Eye Control shall provide 4 preset lighting scenes and 'off' for up to 24 control zones. Control shall be capable of storing an additional 12 preset lighting scenes which can be accessed via wallstations and/or control interfaces. Up to 64 zones may be tied together in one system. 2. Press Scene 1 buttonon front of the GRAFIK Eye Control Unit. The Scene 1 LED will light. 3. Press zone or to raise or lower the light levels. Make sure that the Control Unit is dimming all connected loads. Refer to Appendix C: Troubleshooting, or call Lutron. Connect Class 2/PELV wiringonly if your project has. I GRAFIK Eye ® QS Installation and Operation Guide 6 Wiring the GRAFIK Eye ® QS: Line Voltage Wiring Details (continued) Step 4: Connect line voltage and loads to control unit. • Strip 5/16 inch (8 mm) of insulation off the line voltage/mains cables in the wallbox. • Connect the line voltage/mains, ground, and load wires to the appropriate.


Note: See the zone setup section for a list of compatible load types and instructions for programming the. GRAFIK Eye QS control unit to properly recognize them. Easy to program and operate. Products. GRAFIK Eye , GRAFIK Integrale, GRAFIK Eye Recommended specifications. Programming of preset scenes shall be. 17 févr. to the operating instructions provided by Lutron and the applicable provisions of the national electrical. Code and of the Safety Standards.

0コメント

  • 1000 / 1000