Isilon command line interface manual

Procedure. Open a secure shell (SSH) connection to any node in the cluster and log in. Open the isi config command prompt by running the following command: isi config. Run the lnnset command. The following command switches the LNN of . Unless otherwise noted, run the commands from the OneFS command-line interface as the root user. Procedure Run the following command to check for jobs or devices that report a status of ATTENTION, SMARTFAIL, or DOWN. If the node pools automatically provisioned by OneFS do not meet your needs, you can configure node pools manually. You do this by moving nodes from an existing node pool into the manual node pool. This capability enables you to store data on specific nodes according to your purposes, and is available only through the OneFS command-line interface. CAUTION: It is .

The isi networks command is the most popular and widely used command to get network information about an Isilon cluster, but there is another way to get detailed information about networking info when you are troubleshooting OneFS. Use the folloing commands: # isi config status advanced interface. OneFS provides several interfaces for managing Isilon clusters. Connecting to the cluster. Isilon cluster access is provided through the web administration interface or through SSH. You can use a serial connection to perform cluster administration tasks through the command-line interface. b. If you are using MXFserver in Workgroup mode, Connect to the EMC Isilon OneFS command line interface using an SSH client such as PuTTY and log in as root. From the EMC Isilon OneFS command line, change directories to the UserWorkspaces subfolder: cd /ifs/Workspaces/UserWorkspaces.

^ "OneFS Command Line Reference"". ^ Aqib Kazi (November ). "Isilon. MXFserver EMC Isilon Installation Manual 1. MXFserver system OneFS command line interface using an SSH client such as PuTTY and log in as root. Introduction to the OneFS command-line interface The Network Time Protocol (NTP) service is configurable manually, so you can ensure that all nodes in a.